KNX IP Interface 740.1 wireless

The KNX IP Interface 740.1 wireless serves as a wireless interface to the KNX bus based on WLAN. The device can be used as a programming interface for the ETS® and is a wireless alternative to USB or wired IP interfaces. The bus access via WIFI allows the installer to move freely in the building with his laptop to a large extent.

The KNX IP Interface 740.1 wireless has an integrated WIFI access point to which the laptop can connect. Alternatively, the device can be connected to an existing WIFI in client mode, the connection can be made via WPS (WIFI Protected Setup). The device supports the security standard WPA2. Power is supplied via the KNX bus.

Protection type:	IP20
CE marking according to:	Low voltage directive 2014 / 35 / EUEMC directive 2014 / 30 / EURadio equipment directive 2014 / 53 / EURoHS directive 2011 / 65 / EUEN 63044-3: 2018, EN 63044-5-1: 2019EN 63044-5-2: 2019, EN 63044-5-3: 2019EN 61000-6-2: 2019EN 61000-6-3: 2007 + A1: 2011EN 300 328: V2.1.1EN 63000: 2018
Ambient temp. Operating:	-5 … + 45 °C
Ambient temp. non-op.:	– 25 … + 70 °C
Rel. humidity (non-condensing):	5 … 93 %
Housing:	plastic (PS)
Weight:	approx. 150 g
Controls and indicators:	1 button and 3 LEDs (green)KNX programming button with LED (red)
KNX:	Medium TPInterface protocol: cEMIMax. APDU length: 55Device model: System B
Power supply:	KNX Bus approx. 22 mA
Connectors:	Pluggable screw connector for KNX busSMA for antenna
Installation Instructions:	The device may be used for installations in dry locations
Dimension:	125 x 67 x 31 mm without antenna
RF Interface:	WIFI, 802.11b/g/n, 2.4 GHz, WPA2Supported internet protocols ARP, ICMP, IGMP, UDP/IP and DHCP, KNXnet/IP TunnelingOutput power: 18 dBm

Produktdetails