KNX IP Multi IO 580 (48I/O)

The KNX IP Multi IO 580 (48I/O) is a universal binary interface for building control. It provides 48 I/O lines. Each line can be used as binary input as well as binary output. The peripherals can be fed by an external voltage of 24 V⎓. Channels which are configured as inputs can be used to control lights or blinds via the KNX network. They also can be used to count impulses, e.g. as interface for energy meters. Channels which are configured as outputs can directly drive signal LEDs, external coupling relays (e.g. Multi IO Extension Switch 590) or jalousie relays (Multi IO Extension Switch 592).

The device works using the medium KNX IP. It can be configured using the ETS with native parameters and standard group objects. Also the KNX addressing scheme, based on individual device address and group objects, is unchanged. An easy to read OLED display on the front panel enables a manual operation to test the Installation.

Protection type:	IP20
CE marking according to:	EMC directive 2014 / 30 / EURoHS directive 2011 / 65 / EUEN 63044-3: 2018EN 50491-5-1: 2010EN 50491-5-2: 2010, EN 50491-5-3: 2010EN 61000-6-2: 2019EN 61000-6-3: 2007 + A1: 2011EN 63000: 2018
Ambient temp. Operating:	– 5 … + 45 °C
Ambient temp. non-op.:	– 25 … + 70 °C
Rel. humidity (non-condensing):	5 … 93 %
Housing:	plastic (PC)
DIN rail mounted device:	width: 6 units (108 mm)
Weight:	approx. 260 g
Controls and indicators:	OLED display with 4 buttonsKNX programming LED (red)
KNX:	Medium IP
Power supply:	I/O lines: 24 V⎓, ca. 45 mA with no load
Connectors:	LAN RJ-45 socketPluggable screw connectors (4 poles) for power supplyPluggable screw connectors (12 poles) for I/O linesCross-section of connectors: 0.14 … 1.5 mm²
Installation Instructions:	The device may be used for permanent interior installations in dry locations, within distribution boards or small casings with DIN rail.
Output:	Open-Drain, each max. 100 mA, incl. flyback diode
Inputs (binary in):	Incl. pull-up resistor

Produktdetails